Stiffener for inner sill for Van with metal load floor and Pickup R/H
ONLY ORDERED FOR CUSTOMER REQUEST
This bracket is the main mounting bracket for the handbrake lever assembly and is welded onto the back of the seat crossmember and to the rear floor section.
Only for Pre rod change cars with twin cable handbrake.
The later type bra...
The original shape air vent used by Austin/Morris/Leyland on the Mini Van,Pick Up and other commercial vehicles with pop up lid-VERY GOOD COPY BUT NOT GENUINE.
known as a 'pie vent' as they where used on 'meals on wheels' vans.
Factory fitted rivet for the mini special wheel arches, the plastic type fitted as standard from 1984 to cover 12" wheels.
16 required but beware of the front rivet on the rear wheel arch as it goes through a double skin. 5/32" TYPE 7/16" LO...
R/H Pick Up Non Genuine body section from back of the cab to rear but less rear the rear quarter that holds the rear lamps.Genuine panels are no longer manufactured but this NON genuine part is the only repair panel available which we have also used...
R/H Pick Up Non Genuine body section from back of the cab to rear but less rear the rear quarter that holds the rear lamps.Genuine panels are no longer manufactured but this NON genuine part is the only repair panel available which we have also used...
Special thread cutting screw 1/4 UNF 1.25" (31mm) long.
Screw to hold the lock assembly on the door of MK3 cars with internal hinges and wind up windows. On new doors or for easy fitment use these special screws with cutting thread (3 sided ...
For MPI only when bonnet hook has been moved to central position.
This plate protects the bonnet lander panel from the hook and acts as a stiffener also
The scrivet for holding the front of the rear wheel Sportspack arch and the rear of the front arch. Rover also used rivet RY612535 as an alternative.
Clip for Door Handle required when changing barrel set. Heavy duty round spire clip specially made for the job.
Small angled bracket fitted by factory to stiffen front wings to A panels
Original MK1/2 shape with correct 1.25" small neck.
Originally made by Winguard these plastic washer bottles for early Minis were often asked for but rarely available.
The original part number for the Winguard MK1 bottle was ADA383...
Bracket from the centre of the transmission tunnel up to the centre of the back seat pan
Fixing stud for latest new type genuine Sportspack arches. (Five required per arch)
Late type centre tunnel just over 12" wide to first floor indentation with brackets-also shown is the electric cable protector strip 24A1463.
ADA36002EC is same but is less a strengthening bracket for pre tensioned seat belts as fitted from ...
Floor pan section with late type outer sill with inner sill all fixed to the floor pan which goes to the edge of the centre tunnel . The jacking point and strengthening bracket are all part of this useful L/H repair section
Floor pan section with late type outer sill with inner sill all fixed to the floor pan which goes to the edge of the centre tunnel . The jacking point and strengthening bracket are all part of this useful R/H repair section
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.