Fitted to rubber mounted subframes from 1976 on this packing piece goes between the front panel and the subframe mounting points. You might be surprised how many of these were fitted to your car when it came out the factory. When replacing the front ...
This is the plastic filler seating to sit on the grille mouldings either end of MK2/3 on grilles. Fit these to protect your bodywork and make the surround look better seated.
Up until December 2003 we would have been embarrased to sell the only chrome
boot hinges available. They were bad fitting, looked poor quality and had so much play in them they were totally useless. But along came a set which does fit and is...
Clip to connect the door opening remote control rod plus the lock control mechanism fits on CZH640/1 and CZH616/7-- 2 per door. Also fits the wastegate on turbo models.
For Minis with sliding windows and external door hinges These genuine L/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee the i...
L/H rear lower corner section of the rear valance on vans.estates.travellers and pick ups
The Heritage produced front wings for the Mini have the correct headlamp round hole. They fit! The proper gauge metal and original tooling ensures that even the novice body man can make them fit properly, no aerial hole or wing side repeater hole. Ca...
This is the non genuine variety and the only chrome type made. The biggest difference between these and the original bumpers is the lack of a rolled lip and they look slightly different. If trying to fit to the rear you may need to bend the bumper li...
Genuine metal battery box. always going rusty owing to the location of where they are fitted. Requires welding in place and preferably painted or protective coat of some kind and remember to check if the battery cover, strap and clips need changing...
This panel is available separately but is fitted on all mini wings. It is required quite often however when fitting a new wing on the ADO16 old 1100 and 1300 cars
The NEW MKI bonnets from Original tooling are now available They are being made from the original tooling and absolutely correct. The exact contours, hinge location, etc. etc. fits all '59 thru '67 models of the Mini.
The front hood or bon...
An essential component for mini floor panel refurbishment-it supports and protects the battery cable under the floor. 1959-89--Very low sales demand so usually supplied to customers order.The previous brackets (3)were fitted under the floor along 2nd...
Bonnet locking pin used for all minis except clubman types.
3/8" unf thread.
For minis with sliding windows and external door hinges.
This is the inner hinge panel with the brackets on to reinforce the areas where the hinges sit. You will require the outer panel also 14A6901 for R/H and 14A6902<...
outer sill panel for van and estate versions r/h from genuine tooling but we consider it a MK3 floor shape pressing-6 flute indentations 6 flute indentations
These 4" wide sills are genuine Rover replacement parts with 6 vents and are for MK3on saloon. Non Genuine is MS63L and a superb copy.
Most/many 1970 cars and Cooper S mk3 had 4 flutes.
They will fit MK1/2 but not origi...
This panel closes off the front of the R/H wheel arch and the heel board.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.