This fitting kit suits all later day 1.25" and 1.5" twin carb set ups where the balance rods between the carbs required are equal length (2.25"), some early carbs had the balance bar with a triangular plate that were a shorter length. The kit has the...
Spacer block between carb and manifold for single HS2 carb. To use on twin carbs the fixing holes need drilling out to size. 7.5mm thick
New Carb Spacer for HS4 carbs with vacuum take off. 7.5mm thick.
Want to add a right-hand tank to your one-tank Mini? This kit includes everything, except the tank, to do it. Included are retaining straps, support brackets that mount to the rear seat back and boot floor, between tank metal fuel line and braided fu...
this rubber mounting kit helps to dampen the pump ticking noise as well as acting as an earth
Spacer with gaskets fitted for any 4 bolt fitting carb such as HS6 HIF range about 9/16" (14.5mm). As this is the only thick spacer you need to check stud length.
The rod with the plate is called the butterfly rod and was fitted to all Cooper twin carb HS2 set ups.
Accelerator bracket for twin carb models, mounts to inlet manifold.
Flat racing type cap with large opening catch in chrome with collar
To fit the collar for this cap you will require 10mm(0.3937")just over 3/8" of petrol tank neck accessable above the body seal to allow fitment, many later cars do not have ...
A genuine original S.U. pump ETHANOL tolerant since 2011/2 that will fit into your original mountings with no hassle. Suitable for all cars with electric "pusher" pumps. Replacement points for this are available as AUB6106A.
An...
PLEASE NOTE: This fuel pump has a refundable £5.00 surcharge on the old unit.
original body with solid state electrics for reliability. see AUF214EN for negative earth cars.