Showing 221 to 240 of 482

This is the right hand linkage lever taht sits on the rods between HS type twin carbs. Sold individually

Complete with screw the choke trunnion is used on nearly all SU carb linkages.

See ACC5062 for carb cable link trunnion also.

For HS4 single pre waxstat carbs with red jet this is the full rebuild kit with the spindle and plain throttle disc and bushes--- see CRK227 for disc with overrun valve.

For HS4 single carbs this is the very least of the parts required for an overhaul kit. If you require the spindle and disc and bushes see CRK121.

Pre waxstat with the red jet is CRK227.

Probably the most changed stud on the mini. This is the length used on every A series engine until the introduction of the sandwich plate when longer ones were required. A stainless steel variety C-STR286 is available which we do recomme...

Large headed screw for safety. Short for securing the van petrol tank 21A291.3/4" long

Complete rebuild kit for the FZX3013 waxstat type jet carb with butterfly spindle, plain butterfly and screws.

For HS4 twin non waxstat carbs with red jet this is the full rebuild kit with the spindle and plain throttle disc and bushes--- see WZX1859 for service kit

The favourite and best needle for Minispares stage one kit. Tested on a rolling road by Peter Baldwin this baby gave the best performance when using our RC40 system, Minispares inlet and exhaust manifold plus a K&N filter.

If us...

If you have an early Mini saloon or Estate/Van or Pickup with the fuel tank sending unit held in by screws, this is the correct screw for you.

Do not forget the special copper washers also 2A2088 and the cork gasket [link]2H10...