This is the metal plate to blank off the mechanical pump hole on the engine block. No longer available from Rover but Mini Spares have them.
HS2 float lid assy, also fits HS4.
A rare chance to do something the easy way and at the same time do it right. A new plastic float, pin, plus needle & seat assembly are already installed into a new float cover lid. Simply remov...
Fuel level sending unit for Mini estate, van and pick-up with the long flat tank under the rear. (Early internal tanks for traveller are no longer available).
Cast alloy type,this intake manifold for twin 1.25"SUs (H2 or H4 -- NOT HS4)
It has been carefully produced to minimize cross-port-flow interference caused by the balance tube and has generous radii in all the right places. Further blending ...
1.5" long ram pipe for 1.25" SU.
General:
Velocity stacks, or ram pipes, are necessary on SU carburettors for a variety of reasons. Running an SU devoid of anything to regulate air flow around the carburettor mouth creates a co...
Stainless steel Non Genuine reproduction tank is in automotive stainless steel and fits all the long wheel base Minis, except for the very early side-tank travellers. Also used on many kit cars and specials owing to its shape.
Because of the...
Plastic Y piece for joining the crankcase breather pipes on Cooper S or any twin carb cars with this ventilation system.
Minispares UK manufactured seal for the non locking standard petrol caps it is now made of a petrol resistant material that will fit any genuine petrol cap.
It has a 60mm outer diameter and a 39mm internal diameter hole which is close enough...
1.5" long ram pipe for 1.5" SU.
General:
Velocity stacks, or ram pipes, are necessary on SU carburettors for a variety of reasons. Running an SU devoid of anything to regulate air flow around the carburettor mouth creates a con...
Clip for holding the choke cable on the HS carb abutment bracket 12G766.
THIS THROTTLE BODY REPLACES THE STANDARD PLASTIC ITEM WHICH SOMETIMES CRACKS OR DISTORTS ON TWIN POINT CARS
The Maniflow steel intake manifold has established the standard by which all others measure themselves. This manifold is specially designed to maximize air flow within the space requirements of a Mini. It accepts either twin 1 1/2" or twin 1 3/4" ...