A post and inner wing repair panel 8" wide for Mk1/2 saloon and MK1 Van/pickup
R/H side--6" from a post section
This kit contains all the floor brackets and mounts required for fitting Minis with 7.5 gallon tank 10/12" wheels or with 165 profile tyres.
The boot board bracket 14A9783 is not included
For 10" wheels with 145 tyres ...
Non genuine rear valance closing panel with subframe mount repair
The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...
Non genuine rear valance closing panel with subframe mount repair
The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...
Hydrolastic cars only this bracket clamps under the clutch pipe and top engine steady bulkhead bracket to retain the brake line and hydrolastic pipe.
Key barrel set for Mk3 onwards door handles and boot handles.
13 piece black trim kit as fitted to MK3 Cooper "S" and Mini from 1970 to-may 1973 when the rear quarter panel trim shape changed deleting ash tray mount
This 13 piece kit is available in factory colours and to the exact design pattern as or...
Mini and Cooper S MK3 correct Mini door and rear quarter trim(4 piece kit in vinyl as per original pattern 1970 to mid 1973. 1973 is when the rear quarter panel trim shape has a cut out where the ash tray mount fitted and if you look and click on dia...
Original shape washer jet for Mk1/2 minis. Made to the same specification as the last type made for rover parts sales with a nut on a loose thread so it can be tightened easily by hand in the engine bay without any modifications. Should be used with ...
Hydrolastic cars only this bracket fits on the bulkhead L/H to hold the Hydro and fuel pipes MK2 on -can be used on earlier cars.
Group 2 fibre glass wheel arches in premium black finish not requiring paint, judged the best on the market available by our customers, they stick out 1.75" including lip, when bodylines (wheel arch and moulding lip) are kept original. Screws are vis...
Fitted to mini variants in the 60s where the oval mirror did not suit such as the Elf and Hornet range,these are an offset square, quadrangle shape flat glass
Available with convex glass M50301 (to order)
Curley fibre glass Mini Miglia wheel arches, approximately 4.8." wide, with front edge 6.9" at widest point. Requires MS127FK brackets. Probably the largest wheel arches used on minis. Please note these are white gel coat not black and w...
Small bracket under the front bumper lip to hold the number plate, sold singly.
For the rear opening type quarter light, glass only in clear, MK3 ON.
Cream crackle less mirror WITH ONE ARM and uses GFK7344 clip on one end,fitted from Oct 1964 to 1965
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.