Special lower seal--fitted to MPI cars from October 1996 show cars chassis no BD134455 ON
Has a lip on inner edge to hold carpet back and tidy internal trim but other than that the CGA2835MS will fit --the full set is
Special lower seal--fitted to MPI cars from October 1996 show cars chassis no BD134455 ON
Has a lip on inner edge to hold carpet back and tidy internal trim but other than that the CGA2835MS will fit --the full set is
Twin point injection cars had a split seal system door frame seal for the front doors,the lower acting as a shield cover for the trim. fitted from chassis no BD134455 ON
Some customers have replaced it by the one piece CGA2835MS<...
Twin point injection cars had a split seal system door frame seal for the front doors,the lower acting as a shield cover for the trim, fitted from chassis no BD134455 ON
Some customers have replaced it by the one piece CGA2835MS<...
genuine front panel for the mini clubman before 1976 when the subframe was rubber mounted.see AAM1022 for rubber mounted type as fitted from 1976 on.
the front of these panels is the same but the subframe mounting bracket on the...
The left side inner fender of the Mini Clubman should have a metal cowling to focus the air from the radiator to the wheel well. The almost sqaure cowling is spot welded to the inner fender. If you are resoting your car properly you will need to ha...
New set of metric studs, bolts, nuts and washers as supplied with the alloy external hinge kit (PEASE NOTE: This kit is NOT suitable for the original hinges). The studs have allen key socket ends to help put them into the hinge easily without damage,...
The best chrome type available with screw and washer.
A headlight trim ring is only the starting point of a good looking car, but you have to start somewhere. Sold singly 2 required per car. These are the original type chrome over solid bras...
This stiffener panel fits inner wheel arch to boot floor and seatpan back. Fitted from 1967. Righthand side.
This stiffener panel fits inner wheel arch to boot floor and seatpan back.
Fitted from 1967. Lefthand side( Tank side ).
Commercial Mini floor extension
It is an essential part for the correct restoration of all the longer wheelbase mini derivatives. From the original tooling.
A great accessory for wind up window minis. Fitted in minutes to make such a difference driving your Mini with the window open. Wonderfull for those that smoke or love fresh air. In a tinted colour to stop bad reflections.
The last type of rod change rib design floor made for the assembly line fits cars from 1973-96-It has a large rib down the centre of the L/H side
This floor produced from genuine tools has the crossmember fitted with the sill panels and ja...
Chrome on plastic. Slightly fatter than the original black plastic mirror fitted from 1980 on this is an ideal cheaper replacement mirror for JPC9848 R/H as fitted by Rover from 1980 on.
Chrome on plastic, slightly fatter than the original black plastic mirror fitted from 1980 on. This is an ideal cheaper replacement mirror for JPC9849 L/H as fitted by Rover from 1980 on.
this r/h waist rail is alreday fitted to a new bodyside CZH430 .
It acts as a stifener on the inside of the bodyside just below the rear side window for strengthening between rear seat pan and B post
the left hand waist rail that is supplied on a new bodyside from us.
Acts as a stiffener on the inside of the bodyside between the rear seat pan and the B post just under the rear opening side window
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.