this inner wing has the grille slats for the radiator cooling.
for MK3 cars with wind up window doors until 1991 when it changed to a large round hole for the cooling fan. If you require this panel with the A panel fitted for ease of fitment...
The front bumper of your Mini should be mounted to this simple 'L' bracket that should in turn be spot welded to the lower edge of your nose panel. Not only is this often damaged in accidents but it also was often removed during modification cycle b...
part inner wing R/H from Damper bracket mounting points forward MK2/3 except Clubman. 1969-91 not Mk1/2 as it has air hole in side
NON genuine panel
Part inner wing L/H from Damper bracket mounting points forward. MK1/2/3 except Clubman. This panel has radiator cooling slats as fitted to 1991
NON genuine panel only as part panel
Mini clubman including 1275 GT front grille badge 1969-1976 models pre facelift in 1976. With 3 pin fiing on rear this is die cast as original, polished and chromed with satin black insignia finished with electric blue metal foil inserts.
Plastic cover for JPC9848MS mirror stem. This will fit original Rover mirrors which are obsolete but is a slightly different shape.
This is the R/H blanking plug in the base of the factory type fitted plastic door mirrors JPC984...
Non return valve to fit end of washer pipe in bottle to stop sludge going up thin bore washer pipe tubing--and stop water to jets draining down,usually fitted to Winguard bottle and GWW506 valve was for original Tudor bottles.
Front of door frame repair panel down to door step L/H non genuine
Subframe mounting panel full length for vans with metal load floor and pickups.
This panel is taller than HMP441008 although some customers have used this panel or its derivatives. The correct size non genuine panel is availabl...
The black windsreen and backlight rubber fillet. Chrome is more popular however.
A single length for a single screen is 37H8052
Genuine Mini Spares product,with single hole jet, for fitting to windscreen scuttle panel with a round hole as original on cars from 1970 to 1980 or any car before the start of the "D" shaped hole in windscreen panel, which takes a GWW8010 jet.
...
Windshield washer fluid original D shape bottle known as 1 pint or 1/2 litre size bottle, for those after originality. This was replaced by the larger bottle to help comply with MOT standards where people complained the bottle was too small to hold ...
Curley Mouldings fibreglass front end, as used on Mini7 and Miglia race cars. Will need trimming for a perfect fit.
Curley Mouldings carbon fibre front end, as used on Mini7 and Miglia race cars. Will need trimming for a perfect fit. Bonnet not included.
Van/Estate rear door skin from window down L/H Non Genuine-No Genuine panel available.
Van/Estate rear skin from window down R/H-Non Genuine and genuine is not available