For minis with sliding windows and external door hinges.
This is the inner hinge panel with the brackets on to reinforce the areas where the hinges sit. You will require the outer panel also 14A6901 for R/H and 14A6902<...
outer sill panel for van and estate versions L/H from genuine tooling but we consider it a MK3 floor shape pressing
Owing to their position on the car and chrome on metal these must be cleaned weekly. They are a direct replacement for MK3 on original number plate lamps and are less the 2 light lens, which are the same fitting for this lamp. These lamps use M4 scre...
No longer available as genuine but this is as near as we can find, although a tighter fit. 1/8" centre hole for wires the plug fits 3/4" hole which is ideal for pattern rear valances and use RFN303 for genuine rear valance and boot floor...
Priced each, 2 of these are fitted to the rear of the front subframe on all cars from 1976 on. These original rubber type can be replaced by alloy or other equivalents, see our accessory catalogue. ALSO SEE 21A2599MS.
promotional sticker to advertise your favourite mini parts supplier who just happens to be the largest in the world bar none- WORD MINI SPARES in white with love heart emblem in middle on clear background -external stickers
promotional sticker to advertise your favourite mini parts supplier who just happens to be the largest in the world bar none- Word MINI SPARES in black with love heart emblem in middle on clear background as external sticker
Left hand outer bracket with reinforcements to stop lamps vibrating when 4 lamps are fitted-original fitment for MPI only.
Sold individually
For Minis with sliding windows and external door hinges These genuine R/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee the i...
door locking handle for all MK2 minis with sliding windows. Thicker than the MK1 you should also have a safety boss 24A1834 fitted at the end of the handle on the door. The passenger door plain handle is no longer available but this will...
From the Heater assembly to air distribution box on the right hand side of the heater and is internal. 45cm long.
fitted from 1976 on rubber mounted subframes this washer goes on the large single tower bolt on the front subframe---fits on top of the standard original rubber seal KGE100050 to stop damage
Require cleaning weekly. Up until December 2003 we would have been embarrased to sell the only chrome boot hinges then available. They were very bad fitting, looked poor quality and had so much play in them they were totally useless. But along came a...
This is the left hand panel see 14A6617 r/h and complete wheel arch 14A9558/9
This is the top part only of the rear wheel arch and does not include the shock absorber mounting turret.
R/H rear lower genuine corner section of the rear valance on vans.estates.travellers and pick ups
Minis most used rubber plug 1.25" wide for holes approximately 7/8".
Fits floor, aerial hole and steering column extra hole and radius arm shroud on MK1/2 minis.These floor plugs vary in number from 11 in a Elf/Hornet,Mk1 and 1994 on cars do...
Towing eye that fits in place of the bolt holding the front panel to the subframe. For stronger later version see KPU100160.
When using certain accessory tow bars make sure the towing eye is in the right position to suit or it w...
Also see kits MSSK017 and MSSK017B
Left hand top hinge -wind up window type minis from 1970 on-- note -the studs actualy thread into the genuine hinge and can be replaced with a bolt if damaged or broken
convex replacement glass for the GAM217A/218A range of wider view mirrors.
available to order as very slow sales
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.