Showing 41 to 60 of 691

Horn push assembly for the Mk1 Morris Mini, Mk1 Morris Mini Cooper and Mk1 Morris Mini Cooper S.

For Austin cars, see 27H6943. This horn push assembly can also be supplied without a centre emblem, see 27H6945

MAIN WIRING LOOM 1969 TO 1976 MK3 998 MINI AND COOPER S. ALTERATOR/PVC COVERED.

Complete with rear loom for electronic fuel pump.

Basic spec is: centre speedo oval dash, single stalk, toggle or mk3 rocker switches, inertia starter, ...

These stainless steel peaks fit under the headlamp rim to give that old 60s style again.

Designed to fit the GDC102 side entry distributor cap as a protection against water, made in rubber.

White version of CDU3374 held on by 2 screws (GFK2257) now commonly fitted which be came standard on twin points, but beware as the MPI lamp was different and used an offset pin bulb GLB344. Pre twin point lamp ...

Many charging system problems can be traced to a malfunctioning voltage regulator. And while the workshop manual gives a detailed procedure for checking and/or adjusting one, the only thing that has ever worked for me is to just replace it!

Same size fitting as the regular indicator bulb GLB382 but only 5 watts with small glass head.

This radiator electric fan was fitted as standard on minis with the large round hole cut out in the inner wing fron 1991 on the last carb models through to the SPI but there was an earler type which is no longer available that was on earlier 1275 coo...

Plastic top sensor for fan and ECU fitted in sandwich plate below thermostat on twin point cars. Originally brown coloured. See also: MDY100040 sealing washer and YMQ105690 wiring harness (This was introduced by Rover in Te...

A must for performance cars or custom cabs these switches have an LED light in the end for seeing in the dark

Exchange ECU-you have to send in your correct old unit for repair -turn around on this is usually 1 week--there are no donor bodies available which is why we require your unit with its part number intact and vehicle spec to ensure you get the correct...

A must for performance cars or custom cabs these switches have an LED light in the end for seeing in the dark

Currently the only battery bar available from rover to fit all saloons. There are however different length rods - see YJH100010/YJJ100040 and 5L1158/9.



Has hole centres at 9.75" and 11.5" for different bat...

On /Off safety swith guard and press starter switch,plus three switches

This plastic bowl kit includes the inner rim to hold your light unit and will obviously not rust like the old originals. You will need a headlamp outer rim so why not fit our own developed stainless steel variety which is cheaper than even chrome bud...

Late model cars have these bright red auxiliary "safety lights" mounted below the rear bumper. They are to be switched on during inclement weather. Upgrade for your safety, a legal rquirement on late cars.

Starting in 1976 the Mini wiper switch was mounted on the steering column on the left hand side until 1984, when it was moved to the right hand side. While the assembly of the turn signal switch and the wiper switch is screwed together on the column...

MK1, 64-67, key start, dynamo; cloth covered and oil filter light. Very few cars still have a functioning oil light switch on the filter head so this loom is sold for cars without oil filter light switch and ignore extra wires.

This loom is...

For customers who wish to colour code their light lens, this smoke(grey) lamp is for the small square side lamp on the wing fitted from 1986. Sold singly

These performance distributors are for Pre A Plus engines and can be fitted with points or LU143A ignition pack can be fitted as an extra. From November 2015 they have fitted what they call 16 ounce Cooper S points. For a cheaper version with curren...

Arrow previous
Arrow next
1 2 3 4 5 ...