Fitted in the early 1275cc carb type engines after 1990 before the injection

catalyst. Fits into the thermostat area.

Fits the first cars with pre engaged starter,side repeaters on wings R/H/D

but no dim/dip relay(pink relay box) --if you have the pink relay use HAM4626--

HAM4626 can of course be used for this and ignore extra wires for dim dip.

This is the solenoid only, for the pre engaged type of starter which is built into the top of the unit - SEE GXE4527.



two bolt fixing



caution! some starters are three bolt, this will not fit them

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm silicon wire and the highest performanc...

Fits on the bulb holder of the wing square side flasher/repeater lamp.

Bulb holder is DCP8004, orange bulb is GLB501A, white bulb is GLB501. sold singly,2 required per car

BEZEL for mk2 on switch panel.



this item is satin finished, though can be polished by customer if required

Set of three screws to hold the lens for the MK1 rear lamp.

This was fitted on the right hand side of the steering wheel for all overseas cars and on UK cars from 1984 -89.

PVC wiring loom for MK1, floor starter with coil on dynamo and single speedo clock only. 1959-62 without temp gauge-to A2S7-197020- before temp gauge fitted.

Same loom in braided is 5L191.

Same loom but for cars with temp gauge in 3...

For Cooper S MK3 with dynamos and 998cc deluxe minis with the speedo and two gauges dynamo type-for alternator type see 5L1331

Complete with rear loom.