A plus bearings have a centre locating indent whereas the earlier blocks had the locating area on the side- These are A plus 10 thou oversize.
Fitted from about 1984 on
VP suffix bearings are made by Mahle with lead indium content f...
This thinner crankshaft oil seal was used on the later belt drive kits with a plastic cover and larger diameter crank gear
This is the longer type cylinder head adaptor tube which allows fitment of the by pass hose without removing the head. The shortened hose GZA2083 slides up the tube and then back down on the water pump tube. Frequently rusted on old head...
Engine front plate gasket for any A series units pre A Plus.
For A plus see GUG705554GM or CAM4700B.
For a superb quality engine block gasket set see GUG701614CS
Gold palladium projected electrode nose which has good ignitability on low voltage for 998/1275 engines in standard form--upgrade to BP6ES. Price is for one spark plug.
Genuine Mini Spares upgraded UK made EN8 screws, specially heat treated in correct places as per original drawings, sold individually without nuts.
Nuts are sold individually as NT605061.
Used on our 1.5 forged and roll...
ACL Main bearings for the crankshaft as preferred by performance engine builders plus 20 thou oversize pre 1985
Sintered copper lead, lead plated,steel backed
Nominal Composition
Copper 74%
Lead 24%
Original equipment quality for factory built engines giving longer life expectancy on road cars under variable conditions of oil and use. These are the 1275cc mains as fitted to A Plus engines with the locating tab in the middle rather than to the ou...
Mini Spares own Universal gasket set for solid wall blocks
For any manual block, includes gaskets for "A"Plus and pre A Plus timing covers, but is less tappet chest cover gaskets. Does not include clutch oil seal.
We now offer an en...
Forget all the universal shape gaskets available - this is the original correct shape made out of thick gasket paper.
genuine block gasket set for 1300 without tappet chest seals or clutch seal
Replacement aftermarket manual engine mount to fit to all Minis (except Auto's). Most mini owners now fit the 21A1902 which is the best fit available made to Rover drawings with the correct rubber flex and special shape which was unknown...
Made in EN214N steel and chrome plated for use with standard iron valve guides.
33.3mm (1.311") inlet valve easily noticable by there odd shape they are claimed to give better flow characteristics in standard or slightly modified engines.
This kit uses the race quality valves and alloy roller tipped rockers but for a cheaper version but identical in power see C-STN21BUDGET. Both kits give more or
less the same gains which is a true 20-25%
This kit gives the same power as the C-STN21 but uses forged 1.5 rockers as opposed to alloy roller tipped type and has road spec valves rather than race type. This makes the kit a little cheaper
For race quality chain see 2H4905EVO.
It only makes sense that if you have your engine out of the car that you replace the timing chain. The chain controls the timing of the camshaft and even a slight amount of wear or stretch c...
For high performance engines an efficient crank damper is a necessity to reduce failure. The standard damper commonly used is barely adequate for the standard engine. Mini Spares has reproduced the original "S" damper and pulley-far superior to the s...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.