Fuse box cover
If your fuse box is fine, but you've lost the lid, this is the cover for 606253A You DON'T want your bonnet prop falling directly on the fuse!
Starter gear,"9" teeth for mini. 10 tooth is wrong for mini and was early Metro.
There is no need to replace the whole starter if you've merely damaged the bendix gear! You can replace the gear with a little persistence and ingenuity.
<...
A perfect reproduction of the license plate lamp that was used on almost every British car of the sixties. Complete assembly but now in plastic as per the last fitted. Known as a D shape lamp.
Minis always looked better and safer from vandalism with a roof ariel.
This is the white lens kit for cars that have side repeater lens on the wing and earlier indicator lens that were held in by the chrome ring. Pre MSSK28 type
for about 1 year from 85-86 during cross over period where front indicator lamp the...
Converts your wind up widows to electric.
Not for cars with crash bars fitted internally in the door such as twin point cars 1997 on.
Battery cut-off switch. FIA approved
Most race sanctioning bodies require the use of this special (diode protection device) cut out allowing the switching off whilst the engine is running without damaging the electrics. The switch has to be ...
Headlamp sundries kit.
Includes two adjuster screws, plastic nutserts, pullback spring. Two kits are required per car.
For MK2/3 lamps without built in reverse lights these are the rubber seals between the lamp base and the car body, this is right hand. The seal between lens and lamp is 37H6778.
originally fitted to 1976-45D type distributors and 41824 distributor that fitted mainly 998/1100cc plus allegro and maxi a real jack of all trades we have found this works on all small bore engines with our new range of 45 and 59d distributor curve...
Made in the UK. Correct fitting stainless steel type with screw and washer at a special low price for any Lucas or Wipac headlight including injection cars.
A headlight trim ring is only the starting point of a good looking car, but you have...
This distributor clamp should not be bent; if it is, either you can't get the dizzy all the way in or it won't grip.
The battery cover made of a special cardboard as fitted to all minis to protect
the battery terminals from metal objects. See also the 14A7666 retaining strap.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
Fitted to cars with the reverse lens built into the rear lamp which became standard in 1976, this is the L/H seal between the lamp and the car body.
Original metal type bulb holder to take the single filament indicator bulb only.
When replacing the 520160A parking switch the inner contact areas on the wiring loom are also worn or damaged so we produced this socket and small length of loom.
Ballast type coil fitted from Aug 1982 up until 1989 998cc cars,
1.6ohms
GCL144 was original equipment and GCL217 was the aftermarket replacement. Our research,sales and feed back shows Intermotor coils to be the best a...
BLACK HT SPARK PLUG LEADS TO FIT 23/25D DISTRIBUTOR WITH SIDE ENTRY CAP (GDC102).
7mm lead set
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.