Electronic ignition kit to fit 45/59D4 distributors.
Designed to do away with points this is a simple drop in installation to fit into your existing distributor. Also see our range of distributors with built in electronics--BAU1962MS & [lin...
This bracket is required to re-locate standard fitment fog lamps on R/H/D cars when fitting corner bars and overiders to the rear bumper.
Only for cars without a Rover fitted remote alarm
can be fitted with the electric window kit
the kit will not activate remotely with the alarm fitted by Rover as standard on later models. Also see MSSk2002 keyless entry kit or [link...
Plastic bulb holder for the wing side mounted flasher on cars from 1986 on--
make sure you change the seal AFU3112 when you dismantle these to stop water corrosion. sold singly, 2 per car required.
Used on Rod change gearboxes and fits on the side of the gearlever alloy housing, the locknut is to prevent the switch being screwed in to far. Use 22A1613 locknut.
See GRA101 for quality rotor arm
Most minis up to 1974 had the 25D type distributor fitted with side or top entry caps. This rotor arm fits both but for any sort of performance use they have failed because the contact blade on the arm is now...
The original blue rotor arm was fited with a blue cap GDC143 to the turbos and were made stronger by moulding and riveting the contact plate to the arm, so if you are looking for an upgrade on your 45D body distributor this is our altern...
This very trick pulley is machined from billet aluminum & black anodized. It is oversized (5") to reduce the speed of the generator or alternator on high rpm engines preventing over charging the system.
When using this pulley with the origi...
Original manufacturer LESS THE GEAR 608092A this same wiper motor has been fitted since the late Mk2 version 1968/9 and is still used on the latest twin points but is wired up to give 2 speed and intermittent wipe.
The gear is ...
This is the oblong metal box attached to the rear of your round centre speed heads to stabilize voltage to the fuel gauge. For Centre clock Speedo only!
made for negative earth only--BR1310
SMALLER 10MM PLUGS FOR THE ALLOY 8 PORT HEAD THESE ARE GREAT FOR ROAD USE
SEE C9E ALSO
Domed shape indicator lamp for all minis with single filament bulb, this is the aftermarket type with a plastic orange lens but if you are looking for the original glass lens type see 2A9013. Fitted up to 1986 and the clips that fit the ...
Slightly hotter running engine plug for A Plus 998 and all 1275cc standard engines. For engine running CR of 9.4 to 10:1
2.2 WATTS and fits back of gauges in cars with 3 extra 52mm round clocks.
Indicator bulb for all mini domed shape front lamps and all rear lamps. Single filament 12 volt 21 watt. Sold individually.
Originally for mini special 20th edition which had 2 clock speedo cluster in front of driver and AAU3296 (ADO16)wing indicators.The special also had 1100cc engine. This front loom only has found its way on certain mini clubmans with corr...
A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This the single spade terminal with an open trumpet
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.