Showing 201 to 220 of 686

Copies of the originals in vinyl

Incorperating the original small clear window to show if the lamp remains switched on.

Copies of the originals in vinyl

Incorperating the original small clear window to show if the lamp remains switched on.

Originally a red cap but now supplied in black, it was only fitted to Ducellier type distributors which were fitted to Mini Metros plus a few 998cc minis.Contact set is GCS119 and the condenser is GSC2113. Rotor arm is [lin...

These strange little amber coloured bulbs are used on the front wing side indicators fitted from 1986 on, should be fitted when a clear colour lens is used. The same bulb in white when using amber coloured lens is GLB501. 5 watt 12 volt....

Ultimate coil from lumenition has spiral bound wire giving instant and greater

resonance. Not Suitable for injection Mini's.

For sports coil for use on resistor type cars 1982 to 1992 with 998cc engine from factory, MSC110<...

A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This is going one better with air horns that have open red trumpets.

Blue in colour these points were used on the latest 59D type distributors from about 1980 on up to the introduction of electronic distributor with only rotor arm."Sliding" points for 59D4 distributors, keep a spare set!

5 watt 12 volt festoon type bulb. For rear number plate light (PRC1230A) & interior lamp.Sold individually

This is a red coloured stop and tail bulb for use in the rear white lens kit so often used on minis from 1976 on.Sold individually

If you have quadoptic headlamps these are the blue bulbs for an upgrade in lighting. Sold individually.

This switch fits under the brake pedal on the floor. See also BMK1903A locknut for this item.

Genuine L/H metal based lamp assembly,this is the only quality part made in UK from original tooling unlike others available from our competitors.

The assembly includes an amber/red lens and the body rubber seal. Fits the left rear of ...

This sleeve fits most Lucas and Unipart coils to give the impression thay are stainless steel. Comes with a s/steel bracket. Covers just over 4.25"(11cm)long

This electric windshield washer pump will replace the pump on cars so equipped or is a good starting point if you are installing washers on a car not previously equipped.

998cc minis with central speedo and alternator from 1972-75. This is a front loom only.

ULTIMATE PLUG FOR SINGLE POINT INJECTION OR ROAD TUNED ENGINES. THESE PLUGS HAVE A GOLD PALLADIUM NOSE FOR GOOD IGNITABILITY ON LOW VOLTAGE AND OFFER PROTECTION

ON ENGINE MANAGEMENT SYSTEMS AND RADIOS. BPR7EIX is now supplied by NGK instead...

The spark plug for twin point injection cars to give good ignitability requiring low voltage with resistors to offer protection of the engine management system car radios and telephones.

Copper core recessed nose for high compression highly tuned engines.

A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...