As fitted from Cooper SE on,it is also fitted to the MPI injection cars with self levelling units. This light unit has a plastic backing and not metal as per our S4700 type.This part is not in a complete lamp but just the glass unit.For ...
Harness from coil to distributor on 1275cc electronic ignition 1990.
Attaches to module(NJC10001) on side of distributor and then to coil.
WHITE IS POSITIVE (+)
WHITE/BLACK IS NEGATIVE (-)
One pair of plastic covers to go over your original Rover spotlamps with Cooper laurel motif.
RELAY FOR STARTER, sometimes green, mainly black ...The relays for the electrics appeared from about 1985 and on all injection cars and are colour coded for ease - number YWB000430 stamped on part is different from part number.
30 amp 5 spad...
This lamp unit comes without a bracket and will fit either side, if your bracket is okay. The unit only comes from Rover with bracket but costs £29-93 so we supply it less a bracket at £10-00 savings. If you require a bracket for the right hand it is...
One pair of plastic covers to go over your original Rover spotlamps with Mini
winged motif(BMW trade mark)
Twin point injection cars had the luxury of a twin speed motor and this is the on off switch and any of you clever enough to convert your heaters will require this. The single speed switch is YUF101090.
Rear fog lamp bracket which attaches to the rear valance. Left hand drive only
If you have fitted the old type overiders and corner bars for the Retro look you will need to fit a modified bracket which is basically the right hand drive brac...
If you have rear lamps with integrated reverse lights this gasket fits between the lens and the lamp body unless you have the rare Altissimo lamps fitted in
Europe from about 1974 to early 80s.
Single speed heater switch for MK3 cars from1970 to 1996 only, as Rover changed to a twin speed heater fan with a new switch YUF101410.
This is the only part available for the heater control panel now..
Quantity requir...
Genuine Rover/Unipart 4 high quality silicone plug leads for twin point injection minis. For use with M4 type coil.
This is the indicator orange coloured bulb you require when the lens is plain
or white coloured. The pins on these are opposite each other whereas the twin point lamps have offset pins GLB344 and appear at a 2 o'clock angle whe...
Fitted from 1996 only this alternator sits higher than originally, with new brackets that will only fit the twin point injection cyl head. A1151-65 type producing 65amps (Was GXE2862 from Unipart). If your battery seems to be always running low it mi...
Headlamp bulb for the 700 series LHD and for Cibie.Sold individually
A low oil pressure warning light switch is available to help protect the engine. The standard one comes on at 7lb-much too late to avoid damage. This one comes on at 20lb and is adjustable up to 120lb. Please note this is now a twin terminal switch, ...
As the injection cars were electronic ignition the 64D distributor is only really a body but still wears, causing problems. Takes GDC156 cap
Oxygen ambient air sensor with green plastic top . Fitted in top of manifold --ALSO KNOWN AS IAT SENSOR-intake air sensor.
Original part, not cheap imported copy
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.