Sealig washer for the brown plastic top sensor GTR206 for fan and ECU fitted in sandwich plate below thermostat on twin point cars --
On /Off safety swith guard and press starter switch, plus one switch--See MSA343-2 and MSA344-3 for extra switches
Coolant temprature transmitter fitted to SPi cars from 1992 until 1996. This transmitter is denoted by it's black plastic end. Mounted to the underside of the inlet manifold.
Black wiper arm for R/H/D with a hook type fitting introduced in 1990. This uses an 11" blade GWB911 made by Bosch which is the best we have found. Sold singly. Will fit any cars from 1970 on with correct blade.
These used to be supplied with a little bracket but it was discontinued by the factory so it now just hangs loose under the dash. But Minispares have re-introduced it as 5L433
twin terminal horn with high tone and open trumpet design-often fitted with the low tone version GGE165 to let people know you really are there.
Alternator bracket for A Plus engines and Pre A+ engines with dynamo fitted. See 12G1053 for earlier Pre A plus alternator bracket.
Fitted under dash rail in cabin
cover for this part is YQH100720PMA
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
Make your classic a little bit safer and racier with these rally type ignition switches.One of these mounted on your dash board will allow you to flick the red cover up, click the switch down and then thumb the button to kick the engine into life. Th...
New brushes will not only preserve the life of the motor but could also make it run faster!
Fits 2 speed motors.
Does not fit square body type motors.
This is the side repeater lamp that first appeared on the Mini Special in 1989
and on some special edition minis and the ADO16 model Austin, Morris and MG 1100/1300. The later 1986 cars had the square lamp PRC9916A fitted.
Electronic Ignition distributor, fitted as standard to all 1300 Carb Cooper models.
Replacement service items for this are:
Cap GDC156
Rotor arm GRA2143
Speedometer illumination lamps
These tiny light sockets snap into the back of the speedometer to light the way. If they won't stay in place check yours for spring tension or missing tangs.
Originally took screw in bulb [link]GLB987...
INDICATOR LAMP WITH ORANGE LENS BUT LESS BULB. Sold singly, 2 per car
Straight rubber connector pipe. The standard vacuum advance distributor is connected to the carb/manifold by a small rubber joint that in turn is mated to metal line that fits the distributor. If the little rubber connector is deteriorated it could a...
This is a black painted lighter version with fittings of our s/steel works bar
SEE also C-AJJ3329 for stainless steel.
These cannot be fitted with front overiders and the bottom moulding of the grille slat and back p...
Reverse Light
Most early Minis did not come stock with a reverse light. This hanging light from Unipart will do the job! It can be conected direct to you gearbox by using
GAE191 switch on rod change gearboxes only.
3" high ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.