Wiring loom, front ant rear for van and estate 1960 to 1962 floor start. Like 3222 loom but with alternator conversion.
Battery bar and fitting kit for all post 1990 cars whcih had the longer battery bolts.
8 Port injection loom with air intake sensor, water temp sender and TPS.
This is the wiring required if you have side repeater lamps on your front wings including bulb holder, grommet and connectors LESS the bulb. The large grommet that sits in the inner wing where the wires go through is YML10654. sold indiv...
MK2 Mini Moke Wiring Harness Set - with Dip Switch on Steering Column. Dynamo
Lightweight billet aluminium distributor hole blanking plug for A+ engines.
Lightweight billet aluminium distributor hole blanking plug for pre A+ engines
The original adjuster bolt is very expensive, this kit has been made in stainless steel for longevity and includes all 3 parts for adjusting the fanbelt tension on mpi cars at a fraction of the price of the OEM setup.
Interior lamp with a black on/off switch and pointed torpedo ends.
Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.
Also there was an alternative lamp with black switch and square ends 13H192 which w...
ECU for mini automatic---Japan spec SPI from 1996 on----
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
HT lead set for 8 port only. 4x leads for use with M4( MPI )type coil mounted on flywheel housing. Black.
Clip to retain the speedo cable to the bulkhead on pre 82 cars approx. This clip is also used to hold the loom to the inner wing on some cars.
Wiper motor kit for all mk2 onwards cars, includes wiper motor, motor gear, wheel boxes, outer tube kit, wiper rack and wiper motor ferrule.
Wiper motor fitting kit to fit all mk2 onwards wiper motors to the bulkhead.
If you want to tune your engine, or you have an engine for which there is no standard distributor available.....the new 123\TUNE is the answer!
123ignition is proud to announce the first fully programmable wireless ignition! Contr...
If you want to tune your engine, or you have an engine for which there is no standard distributor available.....the new 123\TUNE is the answer!
123ignition is proud to announce the first fully programmable wireless ignition! Contro...
Starter solenoid bracket that bolts to the flywheel housing on MK1/2 Cooper S, for non S see part number 12A369.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.