Showing 101 to 120 of 686

Braided rear part loom ONLY for MK1 Minis without a rear heated screen.

This turn signal indicator switch also includes a black button on end for the horn push and a for and aft movement for the activation of high beams. The switch is used on most MK3 Minis and can be distinguished by the use of a plug for interconnectio...

These lens are one piece fitted from Mk2 on until introduction of built in reverse lamps as standard from 1976. Gasket for lens to body is available as 37H6778. Screw set for lens is 37H5751.

Glass "beehive" lenses, either clear or amber, were used on the front turn signals on MKI and MKII Minis. For best colour match they should be replaced in pairs. Part 37H6928 is clear, 37H5531 is red.

Sold singly 2 ...

Domed amber lens in plastic was used on the indicators of all minis and other BMC/Leyland cars the same size as the white lens used on alternative vehicles.

If you change to white remember to fit orange bulbs. If you require the original gla...

factory original fuel pump resistor for Turbos

These fit twin point only as they have a loom safety socket fitting.

This is the original correct colour orange (amber) lens for the side repeater lamp on the wing fitted up to the twin point cars which had white.

A white lens AHU2592W is available and fitted to 1996 on cars but remember to fit a...

Exchange ECU-you have to send in your correct old unit for repair -turn around on this is usually 1 week--there are no donor bodies available which is why we require your unit with its part number intact and vehicle spec to ensure you get the correct...

This is the throttle position sensor for single point injection. Fits on end of throttle butterfly spindle. These are now upgraded hall effect sensors making them more relaible than the originals which are no longer available.

1275 cc 1992 on with HIF38 carb and open loop catalyst

Economy battery cut-off switch.

Most race sanctioning bodies require the use of a kill switch for easy and complete cut-off of power from the battery. The switch has to be accessible from inside and outside the car; the external trigger...

Brand new 45 amp uprated alternator without any surcharges comes with the pulleys fittted which are worth over ten pounds retail. This will cope with all those extras you might have bolted on such as spots and music systems.

Replaces the ori...

Fuel and Ignition ECU for twin point cars from 134455 to 137649 earlier models.

part numbers are often on these units and this was originally MKC104290

Exchange ECU-you have to send in your old unit for repair -turn around on this i...

INDICATOR LAMP WITH WHITE LENS LESS BULB. sold singly,2 required per car

This distributor is for Pre A Plus race or High performance engines and can be fitted with points or LU143A ignition pack can be fitted as an extra

LIGHT SWITCH MK3 ILLUMIN, currently in short supply use YUF101030

This is supplied in parts as a bowl with inner rim,sealed beam amd outer rim, easy to install and a lot easier to cope with than trying to repair that rusted or bent old unit. High quality sealed beam lamps with a plastic bowl and Minispares stainle...

this lamp was fitted into the headlining at the end of 1984 and replaced the earlier type lamp EAM1650---(bulb not included) GLB245 but GLB207 is a 5 watt alternative that many cutomers use.

Also fitted to some Land...

Arrow previous
Arrow next
4 5 6 7 8 ...