Showing 401 to 420 of 691

Solid state ignition coil. M4 type for twin point injection minis.

Plugs on the current MPI coils are very snug but do fit.

Original mini coil fitted to all cars up to 1983.

3ohms

NOT for ballast type ignition systems.

Our research, sales and feed back shows Intermotor coils to be the best available for the mini.

Original type coil bra...

Brand new Inertia starter with the correct 9 tooth pinion for all minis up to the fitment of the pre engaged type in 1984/5. Do not fit the 10 tooth starter sold by many as it can ruin the ringear or the bendix. Other leyland cars used 10 teeth such ...

One pair of S6007 halogen driving lamps 135mm wide by 35mm deep approximately plus a pair of XBU10046 stainless steel brackets. The MONTE3 kit is double these parts.

Kit contains 4 S6007 halogen driving lamps with 4 XBU10046 stainless steel brackets.

Mini Clubman indicator and side light lens.



Edge of the lens are painted in Grey / Silver colour.

Colour of indicator part is light yellow.



For the orignal chrome finished edge lens with amber / orange c...

Rear fog lamp switch with the orange illumination segment for all vehicles fitted with production fog lamps as standard. 3.1cm tall from 1976 on.

designed for demanding race application and especially high compression motors

where more cranking power can be achieved using much less of the battery power

Designed to give extra and more consistent cranking speeds taking up to less than 50% of current.

This lightweight alternator is favoured by competition users, new design for 2014 these are now a direct replacement for the original alternator so no additional brackets are required. A small amount of wiring required to fit the Mini wiring loom.

On /Off safety swith guard and press starter switch,a red safety light --See MSA337 for extra swith and light, no wiring included.

On /Off safety swith guard and press starter switch,a red and green safety light plus one switch, no wiring included. Plate size 65mm x 135mm.

The dynamo is the heart of the charging system.

Non-tach drive type. These DO NOT come with fan or pulley, reuse your old ones or order replacements. See dynamos with alternator internals for extra power GXE1006 negative earth. ...

Front loom for 1979/82 MK4 Clubmans and 1275GTs. Use rear loom AN145. Fog lamp models.

Rear loom for the clubman estate and van. With reverse and fog lamp.

The best chrome type available with screw and washer.

A headlight trim ring is only the starting point of a good looking car, but you have to start somewhere. Sold singly 2 required per car. These are the original type chrome over solid bras...

A cable/ switch under the pedal on Single point injection cars.

For the extra clocks on twinpont cars with wooden or alloy dash. this loom fits the voltmeter,oil gauge and time clock but only up to 1999 when the clocks were changed to VDO and a different loom YMQ104960 was used which is now obsolete

Original equipment on the twin point cars this is the roof mounting base and the ariel comes seperate-See XUJ100070

special pillar bolt with hexagonal nut area for holding lower alternator fixing point and then between poly vee belt to hold plastic protection cover over pulley and belt system on the twin point minis