Printed circuit board for pre 1989 cars with Smith's 2 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
New lenses do a lot to improve the looks of a car, and may make it more visible. To make sure that they match we recommend that you replace both lenses together.
Fits metal headlamp bowl to fix headlamp outer rim, sold singularly.
KPH for overseas customers but many use 13H4444 which reads 200kph
Front side and indicator L/H lamp for the Mini Clubman range plus Lotus and Maxi. These are copies as the original base tooling by Lucas was scrapped.
Complete with body to lamp seal and lens to lamp seal.
Seperate parts if required...
Rear body harness with speaker wires, known as thick wall type which was replaced by thin wall PVC covered wire type in 1989. AN169 is the thin wall equivalent and occassionly fitted or found on early cars wothout any problems.
...
Voltage stabiliser for clubman/2-3 clock side pod(smiths) up to 1988. Three terminals/br1303/20.
If you have an original 25D type distributor this is an upgraded arm (blade moulded and riveted )for performance use because all the other types available now are likely to fail at high revs. Because the blade is thin,or the rivet sometimes to long a...
Replacement rotor arm for the Electronic 123 range of distributor.
Exchange ECU-you have to send in your correct old unit for repair -turn around on this is usually 1 week--there are no donor bodies available which is why we require your unit with its part number intact and vehicle spec to ensure you get the correct...
Genuine Mini Spares product, fits 3 and 4-synchro gearboxes except for rod change types which use GAE191. This switch replaces the plug on the front of the remote-shift transmission case. It is triggered internally by the shift linkage w...
For those very early 25D type distributors.
with slide on vaccum hose inlet pipe-not the very first screw in type
Front side and indicator R/H lamp for the Mini Clubman range plus Lotus and Maxi. These come with body seal and lens seal complete.
These are copies as the original base tooling by Lucas was scrapped.
Seperate parts if required are ...
Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
the oil seal to fit on 12A1136 distributor housing. Pre A Plus
the earlier housing 2A612 did not have a seal.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.