Showing 421 to 440 of 691

Bracket for bottom of alternator on all twin point injection cars which also held air compressor on Japan and some German cars that had air con as standard.

Also help to mount the fan belt tensioner wheel. Casting number on this item is YLU1...

For wipac quadoptics-replacement bulb holder for lamps also supplied in kit.

Even at normal highway speeds it is common to "outdrive" conventional headlamps. The halogen headlamps have very bright 55/60 watt bulbs. Their special lens gives g...

Fitted under the bonnet on top of the servo. Relay for the engine management on twin point cars only from 1996-except for cars with air conditioning which use YWB101080.

MK3 van loom. Front and rear.

Centre speedo, 2 fuse fusebox, inertia starter alternator,MK3 wiper and light switch, ignition switch can be dash mounted or steering lock type. 1972-75 with 850/998cc engines with mechanical fuel pump. Comes co...

A favourite for specials where room is at a premium and easy access is required for 45D type distributors only--uses GRA2128 rotor arm and obviously discard screws from cap and use existing distributor clips to secure.

some caps...

Rectangular grey plastic with white plastic interior lamp was fitted to minis from 1974 until 1985. 4.25" long and 1.75" wide. From 1984 on Rover recessed the lamp AFU4092 into the headlining. Fitted with GLB239 bulb. The le...

ONLY 2 of these original rover recon units

once sold that will be the last.

Cooper"S" 23D distributor, no vac unit-This is NOT THE ORIGINAL LUCAS ITEM as the original company and tooling no longer exist but is a new copy of the 40819 to work better with modern day fuels. It does have an original type baseplate with a post b...

New lenses do a lot to improve the looks of a car, and may make it more visible. To make sure that they match we recommend that you replace both lenses together.

Modern dry coil with extra strong spark--latest technology but looks the same shape of the wet body original so it looks correct on your classic mini.

Can be mounted anyway up without any chance of leaking. For non ballasted system only.

Bracket for holding the special coil on the twin point mini.

Rocker switch for all models with front fog lights fitted as standard. Please note the lens colour is now green. 6 pins on the back for plastic loom connector.

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system.For any ...

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system. For an...

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system. For any...

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 pre programmed advanced curves built in, a must for any mini with a worn distributor. Full instructions are included with the system. For any A series, A Plus engines...

The floor starter button switch on the early Mini really adds a mark of distinction; it is a classic item that properly dates the vintage of the car. BUT if it becomes intermittent it’s a real pain…you don't even have a battery cable in the engine co...

Special flat 3/8" UNC nut for the reverse light switch GAE191.