Braided wiring loom for 1963-64 1071 Cooper S only, no oil pressure light and longer wires to the voltage regulator box.
Complete with rear loom
This is a dummy control box (GEU6603) for use with the Dynalite alternators, enabling you to keep your engine bay/wiring looking original even when you are using an alternator. All wire can be swapped like for like from your old regulator box except ...
The half bowl for holding original sealed beams into the headlamp bowl om minis and many other headlamps of the 60s and 70s. Sold singly 2 required per car.
Rear body harness with speaker wires, known as thin wall PVC covered wire type in FROM 1989 and occassionly fitted or found on early cars wothout any problems.
All rear body looms are OBSOLETE from Rover but we can get them made up...
Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.
Fits from 103113 chassis number and has 1 plug to the ecu.
Harness to ECU for SPI manual models from chassis number 059822 to chassis number BD 103112 has 1 plug that connects to the ecu.
INDICATOR LAMP WITH ORANGE LENS AND LED BULBS. Sold singly, 2 required per car
INDICATOR LAMP WITH WHITE LENS AND LED BULBS. sold singly,2 required per car
Original S type base plate with pin to alloy for the fitment of the 32ounce points GCS3001 as used on all Cooper S distributors
Interior lamp with square blunt ends. This part superseded 13H192 which originally had the black on/off switch which BMC also fitted as an alternative. Fitted from October 1964 when courtesy light switches were introduced on Cooper from body number 3...
Lightweight competition alternator for all pre 1997 mini's. This unit weighs 3.2kgs and outputs 55 amps. Designed as a direct bolt on replacement but features a multi position mounting bracket so ideal for race cars/custom applications also. Does not...
Exchange ECU-you have to send in your correct old unit for repair -turn around on this is usually 1 week--there are no donor bodies available which is why we require your unit with its part number intact and vehicle spec to ensure you get the correct...
The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system. For an...
This is the plug that fits on the back of the front indicator lamps (XBD100670) on mpi models.
Screw for chrome metal number plate lamp on mk3 19790 on - You will have to drill the lens out to take M4 screw.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.